![]() Hope someone has a little advice to give i'm using the sonnax 2nd and 4th servo kits. leak in the 2nd gear apply circuit (servo assembly or 1-2 accumulator). Does that seem odd? I did find it odd also that my pin and the 2nd gear piston have a little play between spring and washer e-clip? Someone had said i have a worn out spring there I just used the oem spring and on the oem setup it was against all the parts. 700r4 and 4l60e :install the piston in the housing first,then the white. But i never had to grind/file on my tip of my pin at all. I unfortunately had to pull the 4th back out due to my 2nd not pushing in all the way for some odd reason. I just dont have enough room to get anything in there I used a tape measure and figured i needed more than a 1/16th and no more than 1/8th it all looked good with no o-rings had a heck of a time trying to get it together with the o-rings on and now there is like hardly any play at all in the servo and the retaining ring. I was wondering if anyone actually got a dial indicator and checked the pin travel while the tranny was in the vehicle. I dont know if it has been address before, it might have and i'm not finding it but. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |